Smart Standby Mode And Standby Mode - Loewe SoundPort Operating Instructions Manual

SoundPort / SoundPort Compact / SoundPort Mini
Operating instructions

Smart Standby mode and Standby mode

Smart Standby mode
The Smart Standby mode is automatically activated if the following happens at the SoundPort for the
duration of 10 minutes:
- no music is played back,
- there is no incoming or outgoing call,
- no key is pressed at the SoundPort or on the Assist remote control (see page 52),
- no device is connected or disconnected and
- no sync is in progress.
In the Smart Standby mode, some circuit parts (DSP / amplifier, etc.) are switched off in order to save
power in the SoundPort.
The sound port can be aroused from the Smart Standby mode in different ways:
- An iDevice is being connected to the Lightning Connector.
- A mobile device is being linked via Connectivity Easy pairing (NFC).
- Playback with a paired Bluetooth device continues (only if Bluetooth was active as a last source before
the Smart Standby mode).
- Playback with a device at AUDIO IN is continued (only if AUDIO IN was active as a last source before
the Smart Standby mode).
- One of the four SRC device keys
- A linked Bluetooth device is logged off.
- A key of the Assist remote control unit (see page 52) is pressed.
Devices connected to Lightning / USB are also charged in Smart Standby mode of the SoundPort.
Pressing the ON/OFF key
After 4 hours in Smart Standby mode, the SoundPort automatically switches to the Standby mode.
The power consumption in Smart Standby mode is higher than in the Standby mode (see Technical
data on page 55).
Standby mode
1
Press the ON/Off key
In Standby mode, the device can only be switched on again by the ON/OFF key
by the ON/OFF key on the Assist remote control (see page 52)
In the Standby mode, no devices connected to Lightning / USB are charged.
The power consumption in Standby mode is lower than in Smart Standby mode (see Technical data
on page 55).
2
, Handsfree
1
switches the SoundPort to the Standby mode (see below).
to switch the SoundPort to the Standby mode.
, + oder – is pressed.
3 4 5
1
on the SoundPort or
51