Connecting The Water Line (For Plumbed Models Only) - LG GSL360ICEV Owner's Manual

3
After adjusting the difference in the height of
the appliance door, fasten the keeper nut by
rotating it clockwise.
To tighten the nut
If it is impossible to adjust the height of the
appliance door through the above method, level
the door according to the following guide.
[Method2]
1
When the appliance door is removed, loosen
the screw at the bottom of the lower hinge.
2
Insert the appropriate number of ring sheets
between the lower hinge and the lower
bracket. (Total number of ring sheets: 4)
Lower
hinge
Ring
sheet
16
Lower
bracket
3
Resecure the bracket screw after fitting the
ring sheets before refitting the door. When the
door is refitted, steps 1,2 and 3 of adjusting
the height of the door can then be repeated.
CAUTION
• When tilting the appliance backward to loosen
the screw at the bottom of the appliance, two
or more people should hold the handles at the
bottom and rear top side of the appliance.
Connecting the Water Line
(For Plumbed models
Only)
Water Supply Requirements
A cold water supply with water pressure
between 138 kPa and 827 kPa (1.4-8.4 kgf/
cm²) is required to operate the water dispenser.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install
a booster pump to compensate for the low
pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 138 kPa to 827 kPa (1.4-8.4
kgf/cm²)
EN