Install Side Braces - Husky ACR4896B Use And Care Manual

Assembly Instructions
Step 4 - Install Post Assemblies Continued
For Perpendicular Assembly: Bolt together one post assembly through the hole located on the side of the post to
the center hole of the inside angle of bracket using one Hex Bolt (L), one Lock Nut (M) and two Small Washers (N).
The backside of the post must be facing in and the tapered ends of the post slots must be facing down. Repeat post
assembly for the bracket located on the same joist, making sure backside of the post faces in and the tapered ends
of the post slots face down (as illustrated below). Repeat steps for other two post assemblies to the brackets on the
other joist.
Step 5 - Install Side Braces (D)
Line up the top and bottom holes on the ends of the Side Brace (D) with the two holes located on the outer bottom
sides of two post assemblies. Bolt each end of the side brace to the posts assemblies using two Hex Bolt (L), two
Lock Nut (M) and four Small Washers (N) through the top and bottom holes of the side brace and the two holes of
the post. Repeat assembly for the other Side Brace (D) to the other set of post assemblies.
D
D
6
✓
tapered end
of post slots
face down
D
✓
Note: The assembly of the
side braces must be on the
outside of the posts.