Table of Contents
Advertisement
Assembly Instructions
Step 3 - Assemble Upper and Lower Posts (B & C)
Determine desired height of ceiling rack from the ceiling to bottom of the overhead rack. Join the upper and lower
post and line up the holes to the determined height. Bolt Upper Post (B) to Lower Post (C) using two Hex Bolts (L),
two Lock Nuts (M) and four Small Washers (N). Bolt at the top hole location of the lower post and at the bottom hole
location of the upper post where they overlap. Each bolt assembly should be on opposite holes. Repeat assembly
for the remaining three Upper Post (B) and Lower Post (C) at the same height.
27 - 42"
Step 4 - Install Post Assemblies
For Parallel Assembly: Bolt one post assembly to the inside of the installed ceiling angle bracket through the center
hole using one Hex Bolt (L), one Lock Nut (M) and two Small Washers (N). The tapered ends of the post slots must
be facing down. Repeat Post assembly installation to the Ceiling Angle Bracket located on the same joist in the same
manner and orientation. For the other two remaining Post Assemblies, installation will be on the outside of the
ceiling angle bracket. Bolt one each of the post assembly to the outside of the other two installed ceiling angle
brackets located on the other joist using one Hex Bolt (L), one Lock Nut (M) and two Small Washers (N) for each post
assembly. The tapered ends of the post slots must be facing down.
Post Assembly to the inside
of Ceiling Angle Bracket
✓
B
B
C
posts assembled to
the inside of bracket
✓
Note: Must be bolted at the highest
C
point and lowest point of the two
posts and at opposite holes.
posts assembled to
the outside of bracket
tapered
ends
of post
slots face
down
5
Post Assembly to the outside
of Ceiling Angle Bracket
✓
Advertisement
Table of Contents
