Install Ceiling Brackets - Husky ACR4896B Use And Care Manual

Assembly Instructions
Step 2 - Install Ceiling Brackets (A)
Locate and mark the center of ceiling joist with a pencil.
Use a stud finder to locate the joists if ceiling is finished
with drywall. Use Ceiling Angle Bracket as a template to
mark the two end holes of the Ceiling Angle Bracket on
the center line of the joist using a pencil. Drill pilot holes
using a 7/32" drill bit to the marked locations.
Note: Install into solid wood joists only. Brackets must be mounted perfectly in line and square to each other.
Make sure the lag bolts are tight against the joist but DO NOT over-tighten the lag bolts. If they are over-
tightened, the bolt could snap or the hole may be stripped.
Depending on the ceiling rack orientation preference,
measure 48 or 96" from the installed ceiling angle
bracket to determine the location of the second
ceiling angle bracket along the same joist. Must be
measured from the same end of the bracket. Repeat
the steps to install the second ceiling angle bracket in
the same orientation as the first.
96"
Must measure 48" or 96" from same end of each
bracket.
X
A
48"
Install Ceiling Angle Bracket (A) into marked joist
using two Lag Bolts (K) and two Large Washers (O) with
a 9/16" socket wrench. The Lag Bolts should be installed
into the two end holes of the Ceiling Angle Brackets.
X
For the second set of brackets, depending on prefered
orientation, measure 48" or 96" from edge of installed
ceiling angle bracket to the other location for the
next bracket on the other joist. The bracket should be
installed in the same orientation and must measure
48" or 96" from same edge of each bracket. Repeat the
steps to install the second set of ceiling angle brackets
in the same orientation.
Must measure 48" or 96" from same edge of each
bracket.
Note: If spacing in joists do not match up to the desired
assembled size and direction you will need to install an
additional joists to accommodate, see page 3 for options.
4
A
48"
✓
96"