Bestway Lay-Z-Spa 54138 Manual page 13

1.
5.
9.
NOTE: Dry the SPA pool
(only for Hydro-Jet Pro )
Cleaning the spa
Detergent residues and dissolved solids from bathing suits and chemicals may build up on the spa walls. Use soap and water to
clean the walls and rinse thoroughly.
NOTE: DO NOT use hard brushes or abrasive cleaners.
Spa Repair
For Spa inflatable cover
If the spa is torn or punctured, use the provided
heavy-duty repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
Lay-Z-Spa Storage
Before storing, make sure the spa and pump are completely dry. This is essential to extend the life of the spa. We recommend using the pump
to blow dry the spa, pump and pipes. Remove the filter sets and discard the used filter cartridges. Re-attach the two stopper caps onto the spa's
inlet and outlet valves. It is recommended you store the spa in its original package in a warm dry place.
NOTE: Plastic becomes brittle and susceptible to breaking when exposed to subzero temperatures. Freezing can
severely damage the spa. Improper winterization of your spa can void your warranty.
S-S-004815/21x28.5cm/54138AU, 54144AU 澳规SPA说明书/JS-YF-2016-B-06737/英
2.
6.
NOTE: Lift up the spa when
there is only a little water left.
Damages to the handles are
not covered under the warranty.
10.
For Spa Liner
If the spa is torn or punctured, use the provided PVC repair patch and glue (not
included) following these steps:
1. Clean and dry the area to be repaired.
2. Cut the provided PVC patch to appropriate size.
3. Use glue (not included) to coat the one side of the newly cut patch. Make sure the
glue is evenly distributed.
4. Wait for 30 seconds and then place the cut patch with glue over the damaged area.
5. Smooth out any bubbles of air that may be trapped underneath, and press firmly
for two minutes.
6. Wait 30 minutes before inflation.
7. The product is once again ready for use. Repeat this process should further leaks
occur.
3.
7.
NOTE: Dry the water pipe.
NOTE: Dry the SPA pump
11.
(only for Hydro-Jet Pro )
13
4.
8.
2.
S-S-004815