Sealey APSPB.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE
KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1 GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice

regulations are adhered to when using this product.
WARNING! Use caution when handling and assembling the metal components.

The metal may have sharp edges or corners, the use of protective gloves is
recommended.
Locate peg board in a suitable working area.

Keep the work area clean, uncluttered and ensure there is adequate lighting.

Keep the peg board clean and tidy in accordance with good workshop practice.

Keep children and unauthorised persons away from the working area.

DO NOT exceed the weight limit of 20kg (45lb) per panel.

DO NOT use the peg board for any purpose other than that for which it is designed.

DO NOT use in damp work areas.

WARNING! The warnings, cautions and instructions referred to in this instruction

manual cannot cover all possible conditions and situations that may occur. It must
be understood that common sense and caution are factors which cannot be built
into this product, but must be applied by the operator.
2. INTRODUCTION
Use as part of a complete professional garage storage system or an individual storage panel. Perforated storage panel ideal for hanging
tools to keep garage/workshop clean and tidy. All steel construction with a graphite powder coat finish. Supplied with 10 hooks.
Overall Size (W x D x H):
Fig.1
823 x 15 x 490mm
INSTRUCTIONS FOR:
STEEL PEG BOARD
APSPB.V2
MODEL No:
APSPB.V2 Issue No: 1 - 30/07/09