Sealey APICCOMBO1 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this unit.
‰
Always load evenly with the centre of gravity of the load as near the centre as possible.
9
Use the trolley in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the trolley clean and tidy in accordance with good workshop practice.
9
DO NOT use the trolley for any purpose other than that for which it is designed.
8
DO NOT stand on the trolley, use it as a ladder or allow others to ride on the trolley.
8
Use the wheel locks to prevent the trolley from inadvertently moving.
9
DO NOT leave unattended, especially when loaded, unless the wheels are locked, chocked or the trolley otherwise secured.
8
DO NOT use trolley on uneven ground and do not run over curbs or steps - use a ramp.
8
DO NOT use trolley if any part is significantly damaged, paying particular attention to the wheels.
8
Keep children and unauthorised persons away from the work area.
9
2. INTRODUCTION
Industrial quality mobile storage system for use in the garage or workshop environment. Supplied with six panels; three louvred panels, to accept
storage bins, and three perforated panels which can be used with Sealey TTS clips for tool storage. These can be mounted in any configuration,
allowing the user to customise the design to suit their needs. It also includes a single shelf, which can be mounted at various heights. Four heavy-
duty castors, of which two are fitted with toe locks, give smooth manoeuvrability around the workplace.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . APICCOMBO1
Overall Size (W x D x H): . . . . . . . . . . . . . . . . 960 x 640 x 1605mm
Perforated Panel Size (x3) (W x H): . . . . . . . . . . . . . 925 x 1350mm
Louvred Panel Size (x3) (W x H): . . . . . . . . . . . . . . . 925 x 1350mm
Weight:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60kg
© Jack Sealey Limited
INSTRUCTIONS FOR:
INDUSTRIAL MOBILE STORAGE SYSTEM WITH
SHELF
APICCOMBO1
MODEL NO:
Original Language Version
APICCOMBO1 Issue:1 - 23/10/17