Macintosh; For Usb Interface Users; 10.2.4 Or Greater) - Brother MFC-230C Quick Setup Manual

STEP 2
Installing the Driver & Software

For USB Interface Users

2
(For Mac OS
Important
Make sure that you have finished the
instructions from STEP 1 Setting Up the
Machine on pages 4 through 13.
Note
For Mac OS
®
Mac OS X 10.2.4 or greater. (For the latest
information for Mac OS
http://solutions.brother.com)
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Insert the USB cable into the USB socket
marked with a
USB socket inside the machine as shown
below.
20
®
X 10.2.4 or greater)
®
X 10.2.0 to 10.2.3 users, upgrade to
®
X, visit
symbol. You will find the
3
Carefully route the USB cable through the
trench and out the back of the machine as
shown below and connect the cable to your
®

Macintosh

.
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your Macintosh
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
• Make sure you use a USB 2.0 cable that is no
longer than 6 feet (2 meters) long.
4
Lift the scanner cover to release the lock ( ).
Gently push the scanner cover support down
( ) and close the scanner cover ( ).
®
Macintosh
®
.