Brother DCP-165C User Manual page 77

Error Message Cause
One or more of the ink cartridges
Cannot Print
are empty. The machine will stop all
Replace XX Ink
print operations.
The scanner cover is not closed
Cover is Open
completely.
Close Ink Cover The ink cartridge cover is not
completely closed.
Data Remaining Print data is left in the machine's
memory.
High Temperature The print head is too warm.
Hub is Unusable. A Hub or USB Flash memory drive
with a Hub has been connected to
the USB direct interface.
Init Unable XX The machine has a mechanical
problem.
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
The indicated ink cartridge is
Ink Low Black
running out of ink.
Ink Low Yellow
Ink Low Cyan
Ink Low Magenta
The print head is too cold.
Low Temperature
The memory card is either
Media Error
corrupted, improperly formatted, or
there is a problem with the memory
card.
Media is Full. The memory card or USB flash
memory drive you are using already
contains 999 files.
An ink cartridge is not installed
No Cartridge
properly.
The memory card or USB Flash
No File
memory drive in the media drive
does not contain a .JPG file.
Troubleshooting and Routine Maintenance
Action
Replace the empty ink cartridges. (See
Replacing the ink cartridges on page 69.)
Lift the scanner cover and then close it again.
Firmly close the ink cartridge cover until it clicks.
Press Stop/Exit. The machine will cancel the job
and clear it from the memory. Try to print again.
Allow the machine to cool down.
A Hub or USB Flash memory drive with a Hub
are not supported. Unplug the device from the
USB direct interface.
Open the scanner cover and look inside the
machine for any foreign objects. If the error
message continues, disconnect the machine
from the power source for several minutes then
reconnect it.
Order a new ink cartridge. You can continue
printing until the LCD display shows
Cannot Print. (See Ordering accessories
and supplies on page ii)
Allow the machine to warm up.
Put the card firmly into the slot again to make
sure it is in the correct position. If the error
remains, check the media drive (slot) of the
machine by putting in another media card that
you know is working.
Your machine can only save to your memory
card or USB flash memory drive if it contains less
than 999 files. Try deleting unused files to free
some space and try again.
Take out the new ink cartridge and re-install it
slowly until it clicks. (See Replacing the ink
cartridges on page 69.)
Put the correct memory card or USB Flash
memory drive into the slot again.
B
65