SAT-Kabel TVmeter HD-T Self Repair Instructions

Self Repair
TVmeter HD-T / TVmeter HD
Correct power OFF/ON procedure for meters to avoid occasional
Memory Plans and navigation cancellation
The red button has four timed functions:
1st) One shot = turn-ON
2nd) One shot (when on) = always goes the to HOME MENU
3rd) If kept pressed for 2 seconds = turn-OFF
4th) Kept pressed for about 10 seconds = HW reset, Forced turn-off, (interrupts the
ongoing data saving in memory).
POWER ON:
Press once the red button and wait until the start -up is completed, about 20
seconds (do not press it again during the start-up phase).
POWER OFF:
Press and hold the red button , the instrument will emit a first beep immediately
and a second BEEP after about 2 seconds, then release immediately the red button
(even if the display is still active and shows the batteries instructions).
CAUTION:
Do not keep pressed the red button after the second BEEP, to avoid starting the
HW reset function (forced turn-off see poit 4). Basically, every time you turn off the
instrument, it needs about ten seconds to save the data in memory before turn-off. If
accidentaly you interrupt this storing process, activating the HW Reset function the
data in memory could be corrupted. In any case you can restore the memory plans
yourself with a PC.