Liberty Pumps Builder S30 Series Installation Manual

Liberty Pumps Builder S30 Series Installation Manual

Submersible sump pumps
Hide thumbs Also See for Builder S30 Series:

Advertisement

Quick Links

Installation Manual
S30-Series Submersible Sump Pumps
Builder Series
Models
S35M
1/3 hp
Switchless (Manual) Pump
No Float Switch
S37
1/3 hp
Automatic Pump
Vertical Float Switch
S37-P
1/3 hp
Automatic Pump
Vertical Float Switch
Piggyback (Series) Plug
S38
1/3 hp
Automatic Pump
Wide-Angle Float Switch
Piggyback (Series) Plug
7000 Apple Tree Avenue
Bergen, NY 14416
ph: 800-543-2550
fax: 585-494-1839
www.LibertyPumps.com
Copyright © Liberty Pumps, Inc. 2019 All rights reserved.
7175000H

Advertisement

Table of Contents
loading

Summary of Contents for Liberty Pumps Builder S30 Series

  • Page 1 1/3 hp Automatic Pump Vertical Float Switch Piggyback (Series) Plug 1/3 hp Automatic Pump Wide-Angle Float Switch Piggyback (Series) Plug 7000 Apple Tree Avenue Bergen, NY 14416 ph: 800-543-2550 fax: 585-494-1839 www.LibertyPumps.com Copyright © Liberty Pumps, Inc. 2019 All rights reserved.
  • Page 2 Pump Model #: For replacement manual, visit LibertyPumps.com, or contact Liberty Pumps at 800-543-2550. Pump Serial #: Retain dated sales receipt for warranty. Manufacture Date: Install Date: 2 | EN Copyright © Liberty Pumps, Inc. 2019 All rights reserved. 7175000H...
  • Page 3: Safety Precautions

     For cord replacement: power cord must be of the same  Always disconnect pump(s) from power source(s) before length and type as originally installed on the Liberty Pumps handling or making any adjustments to either the pump(s), product. Use of incorrect cord may lead to exceeding the the pump system, or the control panel.
  • Page 4: General Information

    Contact Liberty Pumps customer service to report any damage or shortage of parts. These pumps are to be used for drain (storm) water. Provide pump serial number in all correspondence.
  • Page 5: Pump System Components

    For added protection, consider the addition of a back-up pump, Clean any debris from the basin. Inspect all remaining equipment such as Liberty Pumps SJ10 SumpJet as well as alarm ALM-P1 or in the basin including piping, valves, and electrical junction boxes ALM-2 in applications where loss of pump function could result in (if present) and repair or replace as appropriate.
  • Page 6: Installation

    Do not lower float below the pump into the piggyback receptacle. minimum TURN OFF level (see Table 1). YES! Temporary Manual Operation Figure 1. Piggyback Switch Operation 6 | EN Copyright © Liberty Pumps, Inc. 2019 All rights reserved. 7175000H...
  • Page 7: Troubleshooting

    To do so may void the warranty. from bottom. Liberty Pumps, Inc. assumes no responsibility for damage or injury due to disassembly in the field. Disassembly, other than an authorized repair facility approved by Liberty Pumps or its authorized service centers, automatically voids warranty.
  • Page 8: Warranty

    Liberty Pumps, Inc. shall not be liable for any loss, damage, or expenses resulting from installation or use of its products, or for indirect, incidental, and consequential damages, including costs of removal, reinstallation or transportation.

This manual is also suitable for:

Builder s35mBuilder s37Builder s37-pBuilder s38

Table of Contents