Related Manuals for Clarke SL2
Summary of Contents for Clarke SL2
- Page 1 SCAFFOLD LADDER MODEL NO: SL2 PART NO: 3500207 ASSEMBLY & OPERATION INSTRUCTIONS LS0614...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE Scaffold Ladder. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. - Page 3 PICTOGRAMS Read the instructions Correct angle of erection Maximum load Ladder extension above landing point Erect on a level base Minimum two rung overlap Do not use the ladder Ensure restraint without fitting the devices are stabilisers engaged Erect on a firm base Do not place the ladder on slippery surfaces.
- Page 4 Do not step off the Beware of electrical side of the ladder hazards when transporting ladder Do not stand the Do not stand the ladder on anything to ladder on anything increase its height. to increase its height. Do not stand on the Ensure ground is free top tread from contaminants...
-
Page 5: Safety Precautions
SAFETY PRECAUTIONS WARNING: IF NORMAL SAFETY PRECAUTIONS ARE NOT FOLLOWED, PERSONAL INJURY TO THE OPERATOR OR DAMAGE TO PROPERTY MAY RESULT. 1. Ensure that you are fit enough to 10. Make sure that the ladder is use a ladder. Certain medical standing on a firm and level conditions or medication, alcohol surface, also ensure the ladder is... - Page 6 FIVE MAIN CAUSES OF ACCIDENTS ON LADDERS The following list of hazards and examples of their causes, which is not exhaustive, are common reasons for accidents encountered when using ladders. 1) LOSS OF STABILITY: 3) SLIP TRIP AND FALL OF USER: a.
-
Page 7: Before Use
BEFORE USE You must fit the stabilisers to the ladder frames before use. FITTING THE STABILISERS 1. Slide the stabiliser into the ladder frame as shown in Fig 1. NOTE: Each stabiliser will only fit one ladder frame, Check that the holes on the ladder frame lines up with the holes on the stabiliser. - Page 8 LADDER CONFIGURATIONS STRAIGHT LADDER • When using the ladder in this configuration, make sure that at least 2 rungs overlap. • Ladder shall be erected an angle of inclination (approximately 1:4) with the rungs or treads level. • Ladder should lean against a flat non-fragile surface and should be secured before use, e.g.
-
Page 9: Working Platform
WORKING PLATFORM • Place the platform onto the required rungs as shown. NOTE: To maintain stability, do not place the platform on the top two rungs of the ladders. • Connect the attachable restraints (one each side) as shown below. STAIR LADDER •... -
Page 10: Using The Ladder
USING THE LADDER 1. Do not exceed the maximum total load for the type of ladder; 2. Do not overreach; user should keep their belt buckle (navel) inside the stiles and both feet on the same step/rung throughout the task; 3. -
Page 11: Repair And Maintenance
REPAIR AND MAINTENANCE • Repairs and maintenance shall be carried out by a competent person and be in accordance with the producer's instructions. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the SL2 and is the answer not in the manual?
Questions and answers