Related Manuals for Clarke ALC3-6
Summary of Contents for Clarke ALC3-6
- Page 1 This product conforms with the requiements of EN131 ALUMINIUM COMBINATION LADDER MODEL NO: ALC3-6 PART NO: 3500750 USER INSTRUCTIONS GC0119 ISS-2...
- Page 2 INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
- Page 3 SAFETY SYMBOLS (BSEN131) Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
- Page 4 LADDER SAFETY • DON’T exceed the maximum load stated in the specification. • DON’T use a ladder if you are not fit enough or suffer from giddiness or are not confident with heights. • DON’T stand on the top three rungs or above the maximum marked rung.
- Page 5 ASSEMBLY The stabiliser bar is supplied not attached and must be fitted before using the ladder. Rest it in the notches in the widest of the ladder sections and bolt it in position using a 10 mm wrench. • Ensure the foot faces down. •...
- Page 6 CONFIGURATION AND POSITIONING The ladder can be used in one of the configurations shown. • Extension ladder • Step ladder • Extended step ladder 1. When positioning the ladder take into account risk of collision with the ladder e.g. from pedestrians, vehicles or doors.
- Page 7 SETTING UP AS AN EXTENSION LADDER (1) 1. To create an extension ladder, lay the ladder on a flat surface and extend it until the safety catches secure the each section to the one below. 2. If the upper section needs to be extended further to next locking position release the catch.
Need help?
Do you have a question about the ALC3-6 and is the answer not in the manual?
Questions and answers