Related Manuals for Clarke TL2
Summary of Contents for Clarke TL2
- Page 1 This product conforms to European Standard EN 131 TELESCOPIC LADDER MODEL No: TL2 & TL3 Part No: 3500230, 3500232 USER GUIDE LS0510...
-
Page 2: Specification
INTRODUCTION Thank you for purchasing this CLARKE telescopic ladder. Before using this product, please read this instruction manual thoroughly and carefully follow all directions given. This is for your own safety and for that of others around you, and will also help you achieve long and trouble free service from your purchase. -
Page 3: Safety Symbols
SAFETY SYMBOLS Read all instructions before use Do not use the ladder as a bridge Allow 1m of ladder above the landing point Angle the ladder correctly Erect the ladder on a level base Do not step off of the side of the ladder Ensure the ground is free from contaminants Do not over reach... -
Page 4: Ladder Safety
LADDER SAFETY DON’T exceed the maximum load, this ladder is built for maximum load of 150 kg. DON’T Be tempted to use a ladder if you are not fit enough, or suffer from giddiness or aren’t confident with heights. DON’T stand on the top three rungs. DON’T overreach;... -
Page 5: Before Use
BEFORE USE 1) Visually check the ladder is not damaged and is safe to use at the start of each working day when the ladder is to be used; • General condition sound (clean & dry, free from wet paint, oil, mud etc) •... -
Page 6: Using The Ladder
USING THE LADDER GENERAL This telescopic ladder can be extended from • Closed (fig 1) to • Full length (fig 2) or • Intermediate lengths (fig 3). LOCKING MECHANISM The locking mechanism locks every rung with two steel locking pins that automatically spring into place when the ladder is opened (extended). -
Page 7: Care And Maintenance
OPENING THE LADDER - INTERMEDIATE LENGTH To open the ladder to any intermediate length, proceed as follows: 1. Place the ladder on a firm level surface and put one foot on the lowest rung to stabilise the ladder (fig 8). 2.
Need help?
Do you have a question about the TL2 and is the answer not in the manual?
Questions and answers