General Maintenance; Cleaning - BOWMAN EC Series Installation, Operation, Maintenance Manual

Hydraulic oil coolers
Table of Contents

Advertisement

5.2 General maintenance

While the unit is in operation, weekly inspection of the heat exchanger and its connections
should be made for leaks and externally visible damage. BOWMAN® recommend that the
tubestack should be cleaned and inspected annually and the o rings should be renewed at
this time. Removal of the screws around the periphery of each end cover will allow the end
covers and seals to be removed. The tubestack can then be withdrawn from either end of
the body.

5.3 Cleaning

Whilst we strongly recommend that mechanical and chemical cleaning of the heat exchanger is
carried out only by specialised companies, below are some general guidelines that may be useful;
a)
Removing the end covers allows access to the tube stack, which can be removed
from the body.
b)
Wash the tube plates and tubes using a hand held hose or lance. An industrial steam
cleaner can also be used if available.
c)
Tube brushes can be used to clean through each tube to aid removing stubborn deposits.
Small diameter rods and brushes for tube cleaning are available from companies such as
Rico Industrial Services
d)
Detergents or chemicals suitable for use with the tube material* can be used if
fouling is severe. Allow time for the detergent or chemical cleaner to work, before hosing
down with plenty of water.
e)
The tube stack should be flushed through with clean water to remove all traces
of cleaning chemicals/detergents. If necessary, the cleaning fluid should be neutralised.
When refitting the end covers after cleaning, new 'O' seals must be used
f)
5.4 End cover screw tightening sequence
End covers must be refitted in their original
orientation and tightened to the torque figures
below.
Take Care
Cooler Series
EC
FC
FG
GL
www.ricoservices.co.uk
*Please refer to the spare parts list for details of the tube materials.
Screw Size
Torque (Nm)
M6
8
M8
22
M8
22
M10
37
Cooler Series
Screw Size
GK
M12
JK
M16
PK
M16
RK
M16
Torque (Nm)
54
95
130
130
2 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents