Table of Contents
Advertisement
NL Troubleshooting
Malfunction
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
burns.
58
Cause and Troubleshooting
Remove unauthorized extensions to the wa-
▶
discharge hose. Connect device
Drain pump is clogged.
→ " Cleaning the drain pump", page 51
▶
Drain pump is clogged.
→ " Cleaning the drum", page 49
▶
if the fault is displayed again,
→ " Cleaning the drain pump", page 51
▶
Inlet opening of the rubber sleeve is clogged.
→ " Clean the inlet opening in the rubber sleeve",
▶
Page 53
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
Clean the strainers in the water supply → Page 54.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
During the next wash, reduce by an equal amount.
▶
load the amount of detergent.
Temperature is too high.
Wait for the temperature to drop.
▶
→ " program cancel", page 41
▶
Water level is too high.
Start the program pump down.
▶
Laundry is wedged in the door.
Open the door again.
1.
Remove trapped laundry.
2.
Close the door.
3.
To start the program, press Start/Additional
4.
.
to fill
Advertisement
Table of Contents
