Coolant - Skoda ENYAQ iV 2020 Owner's Manual

Table of Contents

Advertisement

Open the bonnet.
Remove the bonnet stay from the
holder and insert the end of the
stay into the opening in the bon-
net.
Closing
Lift the bonnet.
Unhook the bonnet stay and insert it into the holder.
Fold the bonnet down and release it with a distance of 30 cm
remaining.
Check that the bonnet is closed.
NOTICE
Do not press down on an unclosed bonnet.
Open and close the flap again.

Coolant

Checking the fill level and topping up
Test conditions
✓ The vehicle is on a horizontal surface
✓ Ignition off
Space under the front flap ›
Checking the level
The fill level must be within the
marked range.
If the fill level is below the mark
NOTICE
Risk of damage to the space under the front flap!
Do not top up the coolant above the marked area. The coolant
could be forced out of the cooling system when heated.
NOTICE
There must be a small quantity of coolant in the tank.
Do not add coolant when the tank is empty.
Stop driving! Seek the help of a specialist garage.
Refilling
CAUTION
Risk of scalding!
The cooling system is pressurised.
Do not open the coolant expansion tank cap immediately after
the ignition is stopped and turned off.
Place a wipe on the lid of the tank and carefully unscrew the
lid.
Refill with coolant of the correct specification.
Screw on the cap until it clicks into place.
Coolant
211
, top up the coolant.

Advertisement

Table of Contents
loading

Table of Contents