Getting Started - VTech Bounce & Play Llama Parents' Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of
the electronic module. Use a screwdriver
to loosen the screw and then open up the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten the
screw to secure.
WAR NI NG:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
4