Table of Contents
Advertisement
• Lock operation
I. Pull out the spring pin, turn it counter-clockwise and
position in groove.
II. Re-adjust coil spring tension until you achieve desired
tool balance.
III. Move suspended tool up or down until spring pin
enters groove and locks.
IV. Move tool again to make sure drum is locked.
• Release operation
I. Pull out the spring pin and turn clockwise until it is back in release groove.
II. when spring pin moves into release groove the drum is released.
5-2 Tool or device replacement
•
Never remove the suspended tool or device before making sure the drum lock is engaged
•
Never release drum lock when the spring balancer is unloaded. If released, the fast winding of
the cable can lead to injury.
I.
Lock the drum similar to "5-1 Manual Stop Operation" and remove the suspended tool
or device.
II.
Before attaching, ensure total weight of new tool or device, including all accessories, are
within the specified weight capacity of the spring balancer.
III.
Adjust the coil spring tension at the same time turning the worm gear with wrench and
refer to gauge scale. Clockwise for increasing tension and counter-clockwise
for decreasing tension.
5-3 Cable replacement
•
Cable replacement can be done without the product disassembly. If you need to disassemble
refer to "6-3 Disassembly and Assembly (Figure-5)".
8
DANGER
!
CAUTION
!
I.
Pull down the cable to the maximum cable travel and
then engage manual stop.
II.
After making sure the drum is locked, remove the tool
or device.
III.
Remove the cable set bolt (plug) and pull out the cable
from the drum.
IV.
Separate the collar and shock absorber from old cable
and assemble the new cable.
V.
Attach the cable to the drum on inside of the housing.
VI.
Assemble the cable set bolt (plug)
VII.
After attaching the tool or device to the hook,
release the drum lock by using the manual stop.
Delta Regis Tools Inc.
7370 Commercial Circle
Fort Pierce, FL 34951
www.deltaregis.com
<Figure-3>
Advertisement
Table of Contents
