Table of Contents
Advertisement
1) Attach the main hook of the spring balancer to the
fitting link.
2) Make sure the Spring Balancer can move (rotation or
gradient) freely.
3) Attach an end of the wire rope or secondary chain to
the spring balancer's body.
4) Attach the other end of the wire rope or secondary
chain to a separate fitting link which does not support
the spring balancer.
5) Check the spring balancer is working smoothly with
suspended tool.
•
Use only weights within the capacity range of the Spring Balancer. In this case, calculate
the total weight of tool and accessories (Air hose., wire etc) including the Spring Balancer's
weight.
4-2 Tool and device attachment & Tension adjustment
1) Make sure that the tool or device weight including accessories
are within the Spring Balancer's specified range.
2) Adjust the coil spring tension to be in balance with tool or device.
• Adjust the spiral spring tension with Hex. socket screw key(4mm).
• Turn clockwise for increasing the spiral spring tension, and tum
counter-clockwise for decreasing it.
3) Lift up the Tool or Device to the fitting link.
• Make sure that there is no person or object under the hook, when you attach the hook or
release the manual stopper lock. lf the weight of the tools or device hanging on the hook is
heavier than the maximum spring tension, it could drop and cause personal injury.
4-3 Secure work space
• Excessive cable's exposure or the maximum stroke of the cable could cause damage to the Spring
Balancer and its life would be shortened.
• Check that the working range is within cable stroke range.
• If necessary, adjust the height of Spring Balancer or use a suitable Jig between the
hook and tool.
5. OPERATING INSTRUCTIONS
5-1 Manual stop operation
• Make sure lock is engaged securely. You will hear a click if lock is engaged properly.
CAUTION
!
WARNING
!
CAUTION
!
DANGER
!
Delta Regis Tools Inc.
7370 Commercial Circle
Fort Pierce, FL 34951
www.deltaregis.com
<Figure-1>
<Figue-2>
7
Advertisement
Table of Contents
