Advertisement
6. MAINTENANCE
6.1.
After each use clean the tester clips.
6.2.
Clean the tester casing, jacket and lead with a soft cloth and mild detergent solution.
6.3.
Keep the tester leads loosely coiled during storage without snagging or crushing.
6.4.
DO NOT attempt to repair damaged leads, these must be replaced by your Sealey service agent or a qualified person.
6.5.
DO NOT attempt to repair tester electronics, this must be done by your Sealey service agent or a qualified person.
6.6.
Replace "low" batteries as described in 5.1.5.. observe polarity from fig.2 and read the note on Battery Removal below.
+
+
fig.2
Battery Compartment underside
Remove rubber cover and open battery compartment to remove batteries.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
+
Back
+
Forward
enter
Environmental Protection
WEEE Regulations
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. edmunds, Suffolk,
IP32 7AR
Original Language Version
fig.3
Battery Removal
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
BT2003.V5 Issue: 1 - 28/11/14
Advertisement
