Advertisement
5.3.6. Press < (forward) or > (back) buttons to select battery fully charged:
Yes or No. Press eNTeR to confirm choice.
5.3.7. When the test is complete, the LCD shows the actual volts and CCA. One of the following results will be
displayed.
5.3.8
GOOD & PASS: Battery is capable of holding a charge.
5.3.9
GOOD & RECHARGE: The battery is good but needs to be recharged.
5.3.10 RECHARGE & RETEST: Battery is discharged, the battery condition cannot be determined until it is fully
charged. Recharge and retest.
5.3.11 BAD & REPLACE: The battery will not hold its charge. Replace.
5.3.12. LOAD ERROR: The tested battery is larger than 2000CCA or 200Ah. or the clamps are not connected
properly. Please fully charge the battery and retest after excluding both previous reasons. If reading is the
same, the battery should be replaced immediately.
NOTE! The operator is asked if any accessories are left on as a possible cause. If accessories are left on, the
operator is instructed to charge and retest the battery. If accessories are not left on, the operator is instructed
to replace the battery since the charging system is working and a good battery should have accepted a
charge.
5.3.13. Press < (forward) or > (back) buttons to select result printing: Yes or No. Press eNTeR to confirm choice.
5.3.14. Remove the clamps from the battery after completion of testing.
5.4
SYSTEM TEST
5.4.1. Press "eNTeR" button, you will view the following screen.
5.4.2. Turn off all vehicle accessory loads such as light, air conditioning, radio, etc. before starting the engine.
5.4.3. When the engine is started, one of the three results will be displayed along with the actual reading
measured.
5.4.4. CRANKING VOLTS NORMAL: The system is showing normal draw. Press eNTeR to perform the charging
system test
5.4.5. CRANKING VOLTS LOW: The cranking voltage is below normal limits, troubleshoot the starter with
manufacturer's recommended procedure.
5.4.6. CRANKING VOLTS NO DETECTED: The cranking voltage is not detected.
© Jack Sealey Limited
Original Language Version
BT2003.V5 Issue: 1 - 28/11/14
Advertisement
