Data Output Setup Mode - Hioki 9636-01 Instruction Manual

9
―――――――――――――――――――――――――――
its default.
The digits may not flash, depending on the version
NOTE
of software used for the 3286 (-20). When using a
version of software for which the digits do not flash,
use the
setting.

5.2 DATA OUTPUT SETUP Mode

The DATA OUTPUT function must be enabled in
the DATA OUTPUT SETUP mode.
The DATA OUTPUT SETUP mode also allows
setting the output type, output items and
communications parameters.
The RS-232C communications speed (item 2-04),
RS-232C data length (item 2-05), RS-232C stop bits
(item 2-06) and RS-232C parity bit (item 2-07)
must be set to be the same as the RS-232C
PACKAGE.
1. To activate the DATA OUTPUT SETUP mode, hold
the
turn the 3286 (-20) on.
2. Select the appropriate settings. Use the
MAX/MIN
item number, respectively. The communications
status display (item 2-03) is off by default. Items 2-
04 to 2-07 are displayed by setting the
communications status display to
3. Change the settings as needed using the
I/
――――――――――――――――――――――――
Chapter 5 3286 (-20) Settings
is displayed, then turn the power off.
is displayed, and the option setting reverts to
or
U/ I/
key while pressing the
SET2
keys to increment and decrement the
keys.
key to change the input type
POWER
key to
and
MODE
.
or
U/