Reset To Default Settings - Telecom Behnke 20-2906A-IP Instructions Manual

IP camera Instructions
GB GB
Configuration and Set-up

2.5. Reset to default settings

▸
Disconnect the camera from the power supply
▸
Press and hold the reset key
▸
Continue to hold the reset key and connect
the camera to the power supply
▸ Stop pressing the key when the LED starts
flashing (after approx. 15-30 seconds)
The following settings must be carried out
again after the reset:
For 20-2906A-IP/21-2906A-IP/43-9588/
20-2913A-IP/21-2913A-IP/50-2906A-IP:
▸
1. Allocate camera password
▸
2. Capture mode: 1080P (1920x1080)
▸
3. Powerline frequency: 50 Hz.
▸
4. System/Direct configuration/Network/
Network HTTP: set to Basic
Deactivate "ZeroConf" Enabled
▸
5. Wide dynamic range: off
20-2906A-IP/21-2906A-IP/43-9588/
20-2913A-IP/21-2913A-IP/50-2906A-IP/
43-9582
30
For 43-9582:
▸ 1. Allocate camera password
▸
2. Powerline frequency: 50 Hz
▸
3. HTTP/RTSP password settings:
unencrypted only
For 43-9582A /43-9582B:
▸ 1. Allocate camera password
▸
2. Powerline frequency: 50 Hz
▸
3. System/Direct configuration/Network/
Network HTTP: set to Basic
▸
Deactivate "ZeroConf" Enabled
!
These settings should only
be carried out if the AXIS
web front end is known
well enough.
43-9582A/43-9582B – Remove the cover
panel from the camera to push the reset
button!
www.behnke-online.com