Reset To Default Settings - Telecom Behnke 20-2906A-IP Manual

2.5. Reset to default settings

▸
Disable the camera's power supply
▸
Press and hold the reset key
▸
Continue to hold the reset key and enable the
camera's power supply
▸ When the LED starts flashing (after approx. 15
- 30 seconds), you may let go of the key
The following settings must be performed
again after the reset:
(only 20-2906A-IP/21-2906A-IP/43-9588/
20-2913A-IP/21-2913A-IP/50-2906A-IP)
▸
1. Assign camera password
▸
2. Capture Mode: 1080P (1920x1080)
www.behnke-online.com
Configuration and set-up
▸
3.Powerline frequency: 50 Hz.
▸ 4. system/plain configuration/network/
network HTTP: basic
▸
5. Wide dynamic range: off
only 43-9582:
▸1. Assign camera password
▸2.Powerline frequency: 50 Hz.
▸3. HTTP/RTSP Password Settings:
unencrypted only
!
These settings should only be
carried out if sufficient knowledge
of the AXIS web frontend is
available.
IP camera Instructions
GB
25