Advertisement
Available languages
Available languages
Charging
Pull the rubber plug out of the charging port until the charging port
is fully exposed and insert the charging port of the charger into
the charging socket.
Note: Please use only the original equipment manufactured
charger.
Charging connector
Changing the pads
Turn the machine over, hold the cloth by the edge and pull it off.
Note: Only turn the machine over when the water tank is empty.
4 Operating tips
1.
Push the handle forward to switch off, it should then be vertical and also locked.
2.
Cleaning pad area
Fibres may adhere to the cleaning pad area after repeated use, resulting in reduced adhe-
sion. Use a brush to clean the area from time to time.
3.
Cleaning pads
Please clean the pads under water after use and dry them.
Disposable cleaning pads
It is possible to use disposable cleaning pads as long as they are self-adhesive with Velcro
and match the size of the receptacle.
4.
Water tank
Please fill only pure water and let the water tank run empty after use. If, for example, small
amounts of essential oils are added, the water tank must be cleaned several times until it is
pure and empty.
5 Technical data
Battery 2000 mAh
Working time vacuum cup up to 18 minutes
Working time mop function up to 80 minutes
Charging time 4,5 hours
Power 25+10+70 watts
Water tank 160 ml
Dust tank 180 ml
Filter HEPA filter
Rotation 270
8
Noise level 71dB
Suction power 3300 Pa
Size 300*300*1182 mm
Weight 3,6 kg
Material ABS plastic
6 Troubleshooting
If a malfunction of the unit occurs, please refer to the following troubleshooting table.
The unit does not work:
•
low battery, please charge the battery.
•
change the handle batteries by unscrewing the third screw of the cover plate under the hand-
le and pulling out the battery box
•
check if the unit is charging, because it does not work during charging, then disconnect the
charger and press the power switch
Nozzle does not spray mist
•
check if there is water in the water tank
•
Change the batteries by unscrewing the third screw of the cover plate under the handle and
pulling out the battery box.
•
the nozzle sprays the water when the machine is in operation
Poor cleaning result
•
check the battery voltage
•
the floor is too wet for the cleaning pads or bad function of other cleaning pads
•
use a different vibration frequency depending on the cleanliness of the floor, with a higher
frequency for a cleaner area
There are water spots on the floor
•
too much water has been sprayed
•
use a dry cleaning pad to soak up the water on the floor
7 Safety instructions
Intended use
Please remove large dirt particles or other wet substances before use. This product is not suitable
for sweeping.
Advertisement
