Advertisement
Available languages
Available languages
3 Directions for use
Switching on / off
Pull back the handle after overcoming a slight resistance, the LED and the indica-
tor light come on and the appliance is switched on.
Notes: The unit automatically switches to „sleep
mode" if it is not operated for more than 2 minutes,
the battery indicator flashes. After switching off, the
appliance can be used normally.
Refilling the water tank
Remove the water tank and unscrew the lid. Please use the measuring cup to fill
in pure water. When the water level reaches the „MAX" line, the machine is full and
you can close the lid again.
Hint:
The maximum capacity of the water tank is 160ml
Essential oil or non-foaming additive can be added to the clear water in small
doses.
Please ensure that the water is clean, otherwise the nozzle or pump may clog.
Starting the Mop / Spray
This appliance has a wireless control system for starting and spraying water. Press the power
switch on the handle to start the machine and vibrate the cleaning pads - press again to stop the
machine.
Press and hold the spray switch to spray water. Release it again to stop.
Use / Vacuum function
The SEECODE Vibrating floor cleaner Suction-/mop function has a wireless control system for
starting and vacuuming. Press the power switch under the handle to start the vacuum function and
vibrate the cleaning pads - press again to stop the vacuum function.
Notes:
Do not operate while charging.
When using the water spray function, press and hold the water spray button for 5 seconds
To ensure the sensitivity of the remote control, the time between each button press must be
greater than 1 second
Please note, the product is not waterproof
Spray switch
Main switch
Cleaning the dust box
Open the top cover and remove the dust box. Then open the cover to pour out the dust. Close the
cover and put the dust box back into the appliance.
The maximum capacity of the dust box is 180 ml. Make sure that
the dust box is clean, otherwise the filter may become clogged
and the function of the dust extraction may be affected.
The HEPA filter must be dried before using the suction function
again.
MAX
Mains switch
Vacuum switch
Battery change
Loosen the third screw of the cover plate under the handle and pull out the battery compartment to
change the battery.
Indicator light
The 3 indicator lights show the status of the battery for 100%, 65% and 30%. When the unit has a
low battery level, the 3 lights flash. Please then recharge the unit.
3 lights permanently on - 100%
2 lights permanently on - 65%
1 light permanently on - 30%
3 lights flashing - low battery
Vacuum switch
Mains switch
Advertisement
