kincrome K8114 Manual

Workshop
Creeper Seat
Know Your Product
1. Vinyl Padded Seat
2. Nut & Bolt Drawer (Not Shown)
3. Tool Drawer
4. Support Legs
5. Castors
6. Underseat Storage
7. Can Holder

PRODUCT SPECIFICATIONS

Part No:...........................................................K8114/BK/G/O/W
Weight Capacity:.............................................130kg
Product Dimensions:......................................300mm X 300mm X 425mm

GENERAL SAFETY INFORMATION

1. WARNING! Only use the Kincrome Workshop Creeper Seat on flat, level surfaces.
2. Protect yourself and others by observing all safety information.
3. This instruction manual contains warnings and other important information. PLEASE READ & KEEP FOR FUTURE REFERENCE
4. The information in this manual has been carefully checked and is believed to be entirely reliable and consistent with the product described.
However, no responsibility is assumed for inaccuracies, or liability arising out of the application and use of the equipment described.
5. Should the equipment be used in a manner not specified, the protection provided by the equipment may be impaired and the warranty voided.
6. The owner and/or operator are responsible for maintenance, maintaining all decals or warning labels while in use, maining the unit in good working order. Make sure that the operator
understands all instructions. Safety information shall be emphasized and nderstood prior to usage. The stool shall be inspected per the operating instructions.
7. Keep work area clean & remove excess grease from tools, hands & clothing both before and after use.
8. The Kincrome Creeper seat is specifically designed to be used as a mobile workshop/garage/shed SEAT ONLY, and is not designed for any other purpose.
9. Using the Creeper for any other purpose could be dangerous, cause serious injury/death to yourself & others.
10. NEVER stand on, lie on or operate the Creeper seat at any speed, on rough/exposed uneven surfaces, while intoxicated or under the influence of any drug or medication that can make your
judgment impaired at any time.
11. Beware of imperfections & cracks on the work floor.

UNPACKING

1. Unpack all components from the box.
2. When unpacking the Kincrome Workshop Creeper Seat, carefully inspect it for any damage that may have occurred during transit or storage.
Check for any dents, loose, missing or damaged parts before use.
3. Ensure all packaging material is disposed of as per your local council guide lines.

ASSEMBLY

The Kincrome Workshop Creeper Seat comes flat packed and requires assembly. Follow the instructions below to assemble your Kincrome Workshop Creeper Seat.
1. Layout all the contents and ensure there are no missing/damaged parts (Fig 1).
2. Lay the Vinyl Padded Seat (1) on a clean flat surface, with the drawers (2 & 3) facing up (Fig 2).
3. Using one of the Support Legs (4) align the 4 holes in the Support Leg (4) with the holes of the Vinyl Padded Seat (1). Insert the supplied bolts, spring and flat washer and hand tighten.
4. Assemble the remaining three Support Legs (4) to the Vinyl Padded Seat (1) hand tightening the bolts (leave all bolts loose until completely assembled) (Fig 4).
5. Turnover the Underseat Storage (6), so the storage cavity is facing the floor (Fig 5) and align the holes with the thread on the Support Legs (4) (Fig 6).
(Fig 1)
1
7
6
Construction:..................................................Heavy Gauge Steel
Tool Drawer Max Weight:...............................30kg
Product Weight:..............................................8kg
(Fig 2)
2
3
4
5
K8114/BK/G/O/W
(Fig 3)