Table of Contents
Advertisement
2. The rear of the base of the chair has a vertical flat bar on each side as per
above image (B).
3. To assemble the chair simply lower the back receiver brackets onto the
vertical flat bars until they are fully seated on both sides.
NOTE: Both back receivers need to be lowered onto the flat bars at the same time
and evenly to prevent binding.
WARNING!
Do not assemble the chair if the upholstery or any of the parts of the
chair are damaged. Check all parts carefully before assembling the
chair. If any problem is apparent contact the vendor.
ELECTRICAL CONNECTIONS
NOTE: Make sure all the wires are properly connected to ensure proper function.
(1)
(2)
(3)
(4)
LIFT CHAIR PLACEMENT
Your lift chair should be placed near a standard electrical outlet on dry,
level ground where there is ample room to allow for proper operation. It is
recommended that you have the assistance of an attendant when positioning
the lift chair to avoid the possibility of injury when lifting.
(1) Connector for the motor and wiring
(2) Connector for wiring and adaptor
(3) Connector for adaptor wiring and plug wiring
(4) Hand control connection
PAGE 7
Advertisement
Table of Contents
