Bushnell CELLUCORE 20 Instruction Manual page 10

of your choice to identify this camera. Especially useful for
multi-camera setups. This will be imprinted on each photo.
Default name is "CORE CAM".
PIR DELAY - Selects the length of time that the camera will
ignore additional triggers from the PIR after an animal is
first detected and remains within the sensor's range. During
this user set interval, the camera will not capture photos
or videos. For example, if a second trigger event occurs
7 seconds after the first, but the delay time is set to 10
seconds, the second trigger will be ignored and a new image
will not be captured until the 10 seconds has elapsed. Only
the next trigger that occurs after 10 seconds will take a new
photo/video, and so on. This prevents the card from filling up
with too many redundant images. The default setting is 10
SEC (a ten second delay). From the 10 SEC setting up, delay
settings are in 5 second increments. After scrolling past "59
SEC", settings go from "1 MIN" to "10 MIN" and then progress
to 60 MIN at five-minute increments (15 MIN, 20MIN, etc.).
WORK MODE - Determines when the PIR (passive infrared)
sensor will activate the camera and capture images.
DAY - 6:00 A.M. - 6:00 P.M.
NIGHT - 6:00 P.M. - 6:00 A.M.
24HRS – PIR Sensor triggers 24 hours a day.
Flash Mode:
SHORT RANGE – This is Medium LED output and fast shutter
speed that is designed to capture good images of animals up
close. This setting will provide the longest battery life but the
shortest flash range.
10