Reference
_____ _ ____________
GAIN Gain Selected
Gain 1
Gain 10
Gain 100
Gain 1000
Pull Up/ Pull Down- Open Circuit Detection.
______________________________________ _
Open circuit inputs can be detected by the installation of
resistors to pull the differential input lines to a known state
The two VOPT jumpers can pull the INPUT+ line, via a 100k
resistor R13, to isolated grounds or to the isolated +15volt
supply. To disconnect this pull up/down remove both jumpers.
Resistor R14 pull the INPUT- line to the isolated ground level in
the event of floating inputs. To disconnect this pull down
remove R14.
Page 12
_______________________
Figure 1-9. Gain Selection.
Analog Relay Mux Board
DEFAULT