Related Manuals for FCI MagicMoon
Summary of Contents for FCI MagicMoon
- Page 1 MagicMoon Touchless Soap Dispenser User’s Manual Thank you for choosing the automatic faucet soap dispenser. Please read the instruction carefully before installation. This manual is for your reference only.
-
Page 2: Specifications
Features Hands free sensor operation improves hand washing hygiene. Easy installation and low-cost maintenance Modular one-piece construction with chrome-plated cast brass spout and black throat plate Available with hardwired or battery power Specifications Power 6V (4 x Alkaline D batteries) Sensing Range 5 –... -
Page 3: Part List
Part List Faucet Body Assembly Control Box Assembly Sensor Sensor cable female Nozzle assembly Control box cover Hex screw Control box base Spout Push button O Ring Hose clip Tapered washer Power cable Fixed frame Tube clip Suction tube Clear tubing Bottle cap Brass shank Soap bottle... - Page 4 Construction / Installation Diagram 1. Faucet Soap Assembly Soap Dispenser oftentimes can be mounted in the left or right hole of a 100 m or 200 mm center-set sink. The ability to do this is contingent upon the width of the faucet spout and accessibility to the unit on the underside of the sink (the Motor and Soap Bottle cannot interfere with the water or drain lines).
- Page 5 3. Connect Foam & Air Tubes Connect the foam soap tube and air tube from the foam soap dispenser into the soap tube fitting and air tube fitting found on top of the foam tank case unit, respectively. i. Check soap tube tags and align with correct fittings as indicated on the fitting’s connection label.
- Page 6 Fill / Refill Soap Lift the soap bottle and horizontally pullout the bottle. Remove the plastic bottle cap. Fill the bottle with 2 parts water & one-part soap concentrate. Avoid overfilling the bottle. Return the bottle back into the case unit (fixture frame). Push the green button on the controller to release trapped air &...
-
Page 7: Battery Replacement
Soap Volume Adjustment No adjustments are required for most settings. Factory default soap volume is 4 ml. factory setting should be satisfactory for most installations. To adjust the volume, aim the remote control at sensor eye. Press the plus “Time +” to increase the soap volume and “Time –... -
Page 8: Troubleshooting
Troubleshooting 1. Unit does not operate Check battery power cables are connected. Connect power cables. 2. Soap does not dispense Soap bottle needs refill. Refill 2:1 water & soap. Check soap dispensing nozzle for clog. Clean nozzle with soft cloth. 3.