Gemini EVT User Manual page 22

4. Put your device in QDL mode by following these steps:
a. Plug the device's USB cable into your computer, but DO NOT connect the
magnetic end to your device yet.
b. Ensure the device is turned off (hold down the capture button for 5 seconds)
c. Move the device's mute switch to the forward position. The red area beneath the
switch should not be visible.
d. Hold down the capture button and continue to do so until instructed otherwise.
e. Connect the magnetic end of the USB cable to the device.
f. The device should be recognized by your computer almost immediately.
g. The QFIL program should not display that it's connected to a Qualcomm HS-
USB QDLoader 9008 device. This confirms that your device has successfully
been placed in QDL mode.
5. In Select Build Type, select Flat Build.
6. Change the Programmer Path in QFIL to point to the prog_firehose_ddr file within the
QFIL package you downloaded previously.
a. The Search Path field will automatically update to match this path.
7. Click Load XML and select all packages with the name rawprogram<n>.xml (there should be 6
total packages; rawprogram0 - rawprogram5).
8. Also select all patch<n>.xml files in the same manner (there should also be 6 patch files;
path0.xml - patch5.xml).
9. In the bottom right of the QFIL window, change the Storage Type to ufs.
10. Click the Configuration tab and check the box next to Reset After Download.
Questions? Feedback? Please contact Michael Thot or assign him a Task using this template.
v0.9 | 21