Power & Charging; Powering Off - Gemini EVT User Manual

● Capture Button: Take a picture/video.
○ Currently used to power off the device.
○ This button may not have much tactile feedback, but should still operate correctly
when pressed.
● Power Button: Power unit on/off
○ Currently powers the device on, but does not power off the device.
Power & Charging
Charging
The device comes with a charger and a cable. The cable can be used for charging and
connecting the device to a computer. Polarized magnets will repel the cable when it's not in the
correct orientation.
When you first connect the device to a charging source, there may be red flashing LEDs on the
inside of the right arm. The red LEDs indicate that the battery is depleted but is charging. Most
devices will exit this state and turn on within 30 seconds - 2 minutes. Some have been observed
taking as long as 15 minutes. Please be patient if your device is taking longer than normal; it
may turn on later than you expect.
Powering On
Once the device has charged sufficiently, the LED will turn blue and the device will power on.
There is no additional interaction needed.
After shutting the device down, you can power it back on by connecting it to a charging source
or a computer, or pressing the power button. Once the blue LED indicator turns on, you can
disconnect the device and it will remain powered on.

Powering Off

To power off the device, disconnect the cable and hold down the PoE button. The PoE button
may not have significant tactile feedback. It should still operate correctly when pressed.
Shutting the device down through adb commands is possible, but the device will immediately
power back on since it is connected to USB power. Hold down the PoE button rather than using
adb shutdown.
Questions? Feedback? Please contact Michael Thot or assign him a Task using this template.
v0.9 | 9