Table of Contents
Advertisement
BDT6000R (REV5).ƒ
11/22/99
LED Display Panel On Center Channel Unit
•
Numerical Level Indicator
1
1 .
This display shows the setting for system master volume, and the individual channel levels ("trim
levels") for the center speaker, surround speakers, and subwoofer. The master volume is numbere d
between 0 and 80, the trim levels for the center and surround speakers are between –9 and +9, and
the trim level range for the subwoofer is between -9 and +15. The display dims after 5 seconds.
When DigitalTheater 6000 is muted, the display will blink continuously. The system can be unmuted
by pressing the m u t e button, the v o l u m e up or down buttons, or any input or system mode button.
•
2 .
M o d e G ro u p
2
Dolby Digital
This LED illuminates when the user has selected either the D S S or D V D input, and the system's
decoder has detected a Dolby Digital signal.
2 - c h
This LED illuminates when the 2 - c h mode is selected. 2-channel operation may be selected at any
time, with any input. Sound will only be heard through the left and right speakers (plus subwoofer)
during 2-channel operation.
P ro Logic
This LED illuminates when either the A u d i o or V C R input is selected and the 5 - c h mode on the
remote control is selected. This LED will also illuminate in addition to the Dolby Digital LED when
the DigitalTheater 6000 is sent a digital signal from a DVD player, but for some reason, either the
s o f t w a re or the source unit is not properly config u red for 5.1 channel digital operation. See N O T E
b e l o w.
NOTE: For 5.1 channel digital playback, confirm that your software supports 5.1 channel playback
and select "5.1" on the DVD's main title screen. Also be sure that your DVD player is config u red for
Dolby Digital operation by selecting "Dolby Digital" from your DVD player's set-up menu. Refer to
the instructions that came with your DVD player.
5:45 PM
Page 15
1 5
Hide quick links:
Advertisement
Table of Contents
