Related Manuals for GBC System Four
Summary of Contents for GBC System Four
- Page 1 GBC System Four Binding Machine Instruction Manual For Models: GBC SureBind System Four GBC VeloBind System Four...
- Page 2 4.0 OPERATING INSTRUCTIONS 4.1 Document Assembly 1. Check the bind edge guide alignment by inserting a receiving strip in the strip recess area. Lay a sheet of correctly aligned punched paper on the strip, matching up the holes and the strip so that the strip is not showing at the top or bottom of the paper.
- Page 3 4.0 OPERATING INSTRUCTIONS Binding 1. Turn the machine on, and the "Wait" light will be on. The machine takes about 45 seconds to warm up, and the "Wait" light to go off. 2. Use the selector button to identify whether the document is less than or greater than 1 inch (25 mm).
- Page 4 OPERATING INSTRUCTIONS Debinding 1. Place document to be debound as follows: bound edge against the backstop, small hole in bottom strip over locating pin, edge of document next to bind edge guide. 2 Once the document to be debound is properly located, depress the Bind/Debind selector to place machine in debind mode.