Table of Contents
Advertisement
Metal filters cleaning
WARNING
• Before starting operations make sure the
electrical power supply to the appliance
is disconnected.
Special attention should be reserved to the
metal grease filters. An excess of grease in
the filter, as well as affecting the
performance of the hood, can also be a fire
risk. To avert fires, the filters must be cleaned
regularly at least once a month or more
frequently, in the case of a heavy use of the
appliance.
Remove one filter at a time as shown in
these pictures.
Wash the filters thoroughly with a non-
bleach detergent, either by hand or
machine. Re-assemble the filters, making
sure that the handle faces the outside of the
hood.
Cleaning and maintenance
Replacing the optional carbon filters (for
recirculated installation only)
WARNING
• Before starting operations make sure the
electrical power supply to the appliance
is disconnected.
The carbon filters are capable of retaining
odors until the carbon reaches saturation
level. They cannot be washed and they are
not renewable, therefore, it is
recommended to replace them at least
every six months or more often if the hood is
used often.
1. Access the active carbon filters by
removing the metal filters as described
above.
2. Tilt the two filters by 90° as shown in
(fig.A) and then extract them from their
housing.
Replacement lamps
NOTE:
The lights, if damaged, must be
repaired by Technical Service
only.
13
Advertisement
Table of Contents
