Advertisement
Available languages
Available languages
1/8"
(12mm)
(3.2mm)
22
Tighten PT-Screws using a T-25 torx driver, starting in the
middle of each upright, then the outer screws and lastly the
remaining two to evenly tighten.
24
Cargo Divider Position: Flip the Bed Extender inboard to
act as a cargo divider for your truck bed.
NOTE: Pull tailgate release handle to release buckles
from the tailgate. Before flipping the Bed Extender into the
cargo divider position, secure the buckles/straps on the
top clips while the Bed Extender is outward position, this is
to secure them from swinging. Flip Bed Extender in.
26
PG 6/6
Top and Bottom
Tubes,
Same on
Opposite Side.
Rivet Gun
1/2"
1/8" Rivet
22 in-lbs
(2.5Nm)
NOTE: Do not over tighten as this
may strip out. Fastener will reach
a noticeable stopping point.
Attach plastic upright around the tube juncture, placing
rubber bumpers into the two ends of the upright.
NOTE: The inside of the upright is
stepped to fit correctly around the
23
small and large diameter tubes.
Adjust Strap Buckles to lock into the tailgate when Bed
Extender is deployed.
NOTE: Ensure that buckles are properly inserted into
latches by pulling on the straps after both buckles have
25
been inserted.
Upright is not
positioned in center
of tube joint.
Advertisement
