Graco FinishPro 290 Manual page 2

AIR-ASSISTED SPRAYING
Turn off air
valve at gun.
AIRLESS SPRAYING
Turn safety lever
of gun to OFF.
REINIGUNG
Set function selection switch
to OFF. Unplug sprayer.
WASTE
Remove siphon tube set from
paint and place in flushing fluid.
Use water for water base paint
and miniral spirits for oil base paint.
While continuing to trigger gun, turn
prime valve down and allow flushing
fluid to circulate for 1 to 2 minutes
to clean drain tube.
Set funcion selection switch
to OFF. Lock trigger safety.
GRACO N.V. Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
E-mail: info@graco.be • http://www.graco.be
Bring fluid pressure
up to eliminate tails.
Point gun at area to be sprayed about 30 cm from surface, and begin moving gun before triggering.
A good spray pattern is evenly distributed as it hits surface. Set pressure just high enough to spray without heavy edges.
Use smaller tip size for thinner material and a larger tip size for thicker material if pressure adjustment cannot achieve even spray pattern.
Turn pressure to lowest setting.
Trigger gun to relieve pressure.
Plug in sprayer. Set function
selection switch to AIRLESS.
Turn prime valve horizontal.
FLUSH
PAINT
Raise siphon tube above flushing fluid and
run sprayer for 15 to 30 seconds to drain fluid.
Open prime valve.
Den Funktionswahlschalter auf
Back pressure down
luftunterstütztes Sprintzen
just to point of tails.
stellen.
Lock trigger safety. Put drain tube
in pail. Turn prime valve down.
Hold gun against paint pail. Unlock
trigger safety. Trigger gun and increase
pressure until flushing fluid appears.
Close drain valve. Unlock trigger
safety and trigger gun into flushing
pail to purge fluid from hose.
Remove filters from gun
and sprayer, if installed.
Clean and inspect. Install
filters. Whipe sprayer, hose
and gun with a rag soaked
in water or mineral spirits.
© 2009 Graco N.V. · Form No. 328035 G (rev.A) · 06/09 · Gedruckt in Europa.
Alle Informationen, Illustrationen und Spezifikationen in diesem Dokument basieren auf den neuesten Produktinformationen die zum Zeitpunktder
Publikation erhältlich waren. Wir behalten das Recht vor, zu jeder Zeit Änderungen vornehmen zu können, ohne diese anzukündigen.
Den Luftdruck erhöhen,
um die Ausläufer zu
beseitigen
Remove tip and air cap
from gun.
WASTE
Move gun to flushing pail, hold gun against
pail, trigger gun to thoroughly flush system.
Release trigger and lock trigger safety.
Set function selection switch to AA
(Air-Assisted). Trigger gun and slowly
increase air pressure to blow material
out of gun air passages.
If flushing with water, flush again with mineral
spirits, or Pump Armor, to leave a protective
coating to prevent freezing or corrosion.
Graco Inc. ist ISO 9001 zertifiziert.