Mastercare MB-80 Installation Manual
Integrity bath
Hide thumbs
Also See for MB-80:
- Operating instructions manual (26 pages) ,
- Operation manual (14 pages) ,
- Maintenance manual (16 pages)
Related Manuals for Mastercare MB-80
Summary of Contents for Mastercare MB-80
- Page 1 Integrity Bath Model MB-80 Installation Manual (Specifications & Rough-In Included) Important Safety Instructions Read & Follow All Instructions Thoroughly SN:_____________________________________ Part# 805015...
- Page 2 " Trap should be supplied by customer, not manufacturer) Drain Connection: 2" PVC schedule 40 pipes. CAUTION: The tubs use flexible hoses. It is an industry Water Connection: 3/4" female pipe swivel standard and it is recommended by MasterCare to connections supplied by the manufacturer. replace the hoses every 5 years and to inspect the hoses yearly for any obvious signs of damage or wear. If any Water Supply: 3/4" Copper hot and cold. sign of damage or wear is noticed, replace de hoses. Minimum 40 PSI for hot and cold required.
- Page 3 Slide the vital components. tub back, connect the drain and set the anchors accordingly. • You are now ready to install your MasterCare Integrity Bathing System. Reposition Tub Against Wall Position Tub • Install the anchor bolts loosely. • Remove side service access panel, remove •...
- Page 4 Integrity Bath Model MB-80 Installation Manual DRAWING OR PICTURE OF LEVELING SCREWS AND THEIR Turn On BathAire LOCATION IN THE TUB. • Turn on BathAire by pushing the “BathAire On/Off” button. Tighten Anchor Bolts Turn on Supply Water Make Final Connections • Turn on the hot and cold water supply valves. • With the shower wand pointed inside the tub, turn • Connect hot / cold water high pressure hoses from the chrome shower spray on/of handle counter inside if the support cabinets to the hot and cold clockwise (on) to purge the plumbing system of water supply valves with ¾” male FTT fittings.
- Page 5 If any problems are encountered during checking and adjusting dispensing systems, check the Maintenance Manual included with your tub or call your local MasterCare representative or MasterCare direct for technical support. Clean and Rinse the Bathing System before Using Before using this equipment: • Remove all rough debris from inside the tub.
Need help?
Do you have a question about the MB-80 and is the answer not in the manual?
Questions and answers