Charging - Nokia NPC-1 Series Troubleshooting Instructions

NPC-1
Troubleshooting Instructions
C383 "The Prommer has not received Phone
C583 acknowledge to the message."
C683 (C383-during algorithm download to tar-
get phone)
(C583-during erasing)
(C683-during programming)
C384 "The Phone has generated NAK signal dur-
C584 ing data block transfer."
C684 (C384-during algorithm download to tar-
get phone)
(C584-during erasing)
(C684-during programming)
C585 Data block handling timeout"
C685 (C585-during erasing)
(C685-during programming)
C586 "The status response from the Phone
C686 informs about fail."
(C586-during erasing)
(C686-during programming)

Charging

Note: The charging voltage and current can be checked by connecting the phone to
the service software and reading the ad- converter values of the vchar and ichar.
If charging fails when the ACP-9 or the LCH-9 is used, and works with ACP-7, ACP-8 and
LCH-8, check that the charge control pin of the system connector is connected to the
ground.
Page 12
Flash
UPP
Signals between UPP-Flash
Flash
UPP
Signals between UPP-Flash
Flash
UPP
Signals between UPP-Flash
Flash
ãNokia Corporation
PAMS Technical Documentation
Issue 1 10/01