Table of Contents
Advertisement
7. BASIC OPERATIONS
1) PANEL RELEASE BUTTON (REL)
Press this button to remove the control panel.
12)POWER ON/OFF BUTTON
Press this button to turn on or off the power.
6) DISPLAY BUTTON (DISP)
Press this button briefly, the LCD will display the clock for about 2 seconds, then return to previous
display mode.
Clock Adjustment
Under clock display mode, press DISP button until the LCD flashes, press Tuning Up Button to adjust
hour and Tuning Down Button to adjust minute.
3) VARIABLE COLOR DISPLAY BUTTON (COLOR)
This unit is equipped with variable color display: The display color can keep changing
automatically. Press this button briefly, the display will stop at the color it shows. Press this button
shortly again, it will switch to changing color on display.
16) SOURCE BUTTON (SOURCE)
Press this button to select Radio and CDP modes.
The available selections depends on version:
Radio CD Player
Radio > CDP > AUX in
Sub-woofer On/Off
Press SOURCE button for more than 3 seconds to activate or turn off the Sub-woofer output.
Aux Input
Connect the external signal to the auxiliary line in jack located at the rear of the unit , then
press Source button to select Aux mode. Press Source Button again to cancel Aux Mode and
return to previous mode.
RESET BUTTON
The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a
ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons:
Initial installation of the unit when all wiring is completed.
All the function buttons do not operate.
Error symbol on the display.
Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in
isopropyl alcohol to clean the socket on the back of the control panel.
E - 8
Advertisement
Table of Contents
