Push to Talk key (PTT) Volume down key USB 3.1 port (USB-C) Privacy Mode key Power key (device On/Off) SIM tray Loudspeakers The ambient light sensor and proximity sensor are located next to the status LED. Bittium Tough Mobile 2 Quick Start Guide...
Page 3
Please read this quick guide carefully before using the device. Bittium Tough Mobile 2 is factory tested to be IP67 resistant to dust and water. Intentional underwater immersion of the device should be avoided. The device is not designed for underwater use or use in a shower.
Bittium approved USB-C compatible accessories can be used with the device. Operating system and applications Bittium Tough Mobile 2 uses the Android™ operating system. Android is a trademark of Google LLC. This Quick Start Guide contains only highlights and device-specific features and functionalities. For more information on Android features visit www.
In case you are not using two SIM cards you can insert your Micro SDHC card onto the Dual Mode slot. After the SIM and SD cards are inserted, push the SIM tray back. Bittium Tough Mobile 2 Quick Start Guide...
Page 6
NOTE Device has internal battery which is not user replaceable. Only Bittium authorized service can replace the battery, if required. Once the device has powered up, follow the on- screen instructions to set up the device using the Security Wizard.
Charging Battery <15% Yellow Constant ON or Charging Battery 15–89% Green Constant ON or Charging Battery 90–100% Green Blinking Privacy Battery Mode ON >15% White Blinking Screen Missed notification call or SMS, example Bittium Tough Mobile 2 Quick Start Guide...
Lock screen Switching off the display locks the device. The device also locks after a period of inactivity. Switch the display off by pressing the power key once. Bittium Tough Mobile 2 Quick Start Guide...
See Privacy Mode section on next page for more information. Button descriptions can also be found on the phone’s back cover sticker, which can be removed. Bittium Tough Mobile 2 Quick Start Guide...
Privacy Mode Bittium Tough Mobile 2 can be set to a special privacy mode in which some of the device functionalities are intentionally disabled: • Microphones are disconnected • Bluetooth is disabled • Device cameras are disabled • Sensor accuracy is reduced •...
You can also set the schedule for OTA (over-the-air) updates by tapping Check OTA updates. Options are: Disabled, Daily, Weekly and Monthly. Note that In order to receive over-the-air SW updates minimum 50% battery level must be available. Bittium Tough Mobile 2 Quick Start Guide...
Page 12
Please take the following safety precautions when using the device: WARNINGS Only use the chargers approved by Bittium Wireless Ltd. The use of non-Bittium approved chargers may be dangerous. Permanent hearing loss may occur if earphones or headphones are used at high volume for prolonged periods of time.
Page 13
Always create a backup of data you want to keep (such as contacts and calendar notes) before sending your device for service. Bittium Tough Mobile 2 Quick Start Guide...
Be aware of this restriction when these features are enabled. Tamper detection Bittium Tough Mobile 2 is equipped with hardware and software tamper detection. Upon detection of a tampering event, the user data, including encryption keys, will be erased.
Security Tamper detection level. Important customer information Bittium Tough Mobile 2 is a wireless device, containing a radio transmitter and receiver which emit radio frequency energy during its use. Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the radio signals from a wireless phone.
Page 16
Turn Bittium Tough Mobile 2 OFF in any facility where posted notices so require. To avoid interfering with blasting operations turn Bittium Tough Mobile 2 OFF when in a blasting area or in areas posted: “Turn off two-way radio”. Obey all signs and instructions.
Declaration of conformity Hereby, Bittium Wireless Ltd. declares the Tough Mobile 2 product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found at www.bittium.com.
Consult the radio or television equipment dealer. Radiation exposure statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment Bittium Tough Mobile 2 Quick Start Guide...
The highest SAR value reported under these guidelines when used at the ear is 1.30 W/kg and when correctly worn on the body is 1.44 W/kg. Bittium Tough Mobile 2 Quick Start Guide...
-20°C – +55°C. IMEI information Device IMEI information can be found via Settings About phone IMEI (sim slot 1) and IMEI (sim slot 2). Alternatively you can type *#06# in the phone’s dialer. Bittium Tough Mobile 2 Quick Start Guide...
Bittium to service this Product. For more info on Bittium Tough Mobile 2 Ingress Protection see www.bittium.com. To obtain warranty service, you must receive a Return Authorization from Bittium and ship the Product, at your expense, to Bittium’s authorized...
Page 22
Notes Bittium Tough Mobile 2 Quick Start Guide...
Page 23
Bittium Tough Mobile 2 Quick Start Guide...
Page 24
Bittium makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability or fitness for a particular purpose.
Need help?
Do you have a question about the Tough Mobile 2 and is the answer not in the manual?
Questions and answers