Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bittium Tough Mobile 2
Summary of Contents for Bittium Tough Mobile 2
- Page 1 Bittium Tough Mobile 2 Quick Start Guide...
-
Page 2: Device At A Glance
Push to Talk key (PTT) Volume down key USB 3.1 port (USB-C) Privacy Mode key Power key SIM tray Loudspeakers The ambient light sensor and proximity sensor are located next to the status LED. Bittium Tough Mobile 2 Quick Start Guide... - Page 3 Please read this quick guide carefully be ing the device. Bittium Tough Mobile 2 is factory tested to be IP67 resistant to dust and water. Intentional underwater immersion of the device should be avoided. The device is not designed for underwater use or use in a shower.
-
Page 4: Box Contents
Box contents and the appearance of the accessories may vary. Operating system and applications Bittium Tough Mobile 2 uses the Android operating sys- tem. This Quick Start Guide contains only highlights and device-specific features and functionalities. For a full Android User Guide please refer to: http://www. -
Page 5: Getting Started
SIM card(s). To open the SIM tray insert the SIM tray tool into the hole shown below. Push the tool gently into the hole until the SIM tray pops out. Insert the SIM card and optional SDHC card as shown below. Bittium Tough Mobile 2 Quick Start Guide... - Page 6 Prior to using the device the battery should be fully charged using the charger and the USB cable provided in the sales package. Press the power key to power up the device. Bittium Tough Mobile 2 Quick Start Guide...
-
Page 7: Led Indications
Blinking Battery charging <15% Constant ON or Charging Battery <15% Yellow Constant ON or Charging Battery 15- Green Constant ON or Charging Battery 90- 100% Green Blinking Privacy Battery Mode ON >15% Bittium Tough Mobile 2 Quick Start Guide... -
Page 8: Lock Screen
To open the screen lock and to access the home screen, follow the steps below: 1. Swipe the lock upwards. 2. Enter the screen lock code. 3. Tap the check mark Bittium Tough Mobile 2 Quick Start Guide... -
Page 9: Special Key Functions
The Privacy Mode key switches the device to ‘Do not disturb’ mode. See Privacy Mode section for more in- formation. Privacy Mode Bittium Tough Mobile 2 can be set to a special privacy mode in which some of the device functionalities are intentionally disabled: •... -
Page 10: Software Update
2. Tap ‘Check Now’ to check if an update is available. You can also set the schedule for OTA (over-the-air) updates by tapping Check OTA updates. Options are: Disabled, Daily, Weekly and Monthly. Bittium Tough Mobile 2 Quick Start Guide... - Page 11 Please take the following safety precautions when using the device: WARNINGS Only use the batteries, antennas and chargers ap- proved by Bittium Wireless Ltd. The use of non-Bittium approved batteries, antennas, and chargers may be dangerous Permanent hearing loss may occur if earphones or headphones are used at high volume for prolonged pe- riods of time.
- Page 12 The law in many countries requires the use of a vehicle handsfree solution while driving. Always create a backup of data you want to keep (such as contacts and calendar notes) before sending your de- vice for service. Bittium Tough Mobile 2 Quick Start Guide...
-
Page 13: Important Customer Information
Important customer information Bittium Tough Mobile 2 is a wireless device, containing a radio transmitter and receiver which emit radio fre- quency energy during its use. Most modern electronic equipment is shielded from RF signals. However, cer- tain electronic equipment may not be shielded against the radio signals from a wireless phone. - Page 14 Turn Bittium Tough Mobile 2 OFF in any facility where posted notices so require. To avoid interfering with blasting operations turn Bit- tium Tough Mobile 2 OFF when in a blasting area or in areas posted: “Turn off two-way radio”. Obey all signs and instructions.
-
Page 15: Fcc Notice To Users
FCC radio frequency (RF) Exposure Guidelines. This transmitter must not be co-located or operated in con- junction with any other antenna or transmitter. Bittium Tough Mobile 2 Quick Start Guide... -
Page 16: Specific Absorption Rate (Sar) Certification Information
The highest SAR value report- ed under these guidelines when used at the ear is 0.88 W/kg and when correctly worn on the body is 1.36 W/kg. Bittium Tough Mobile 2 Quick Start Guide... -
Page 17: Frequency Bands And Power
LTE Bands FDD: power 1,2,3,4,5,7,8,12,13,14,17, 20,25,26,28,29,30,66: 25.5dBm, LTE Bands TDD: 34,38,39 25dBm Wi-Fi 2.4G: 16.5dBm, Wi-Fi 5G: 17dBm, Bluetooth: 12.5dBm Operating temperature Device operating temperature range is -20°C - +55°C. Bittium Tough Mobile 2 Quick Start Guide... -
Page 18: Limited Warranty
Limited warranty For a period of 1 year from the date of purchase, Bittium Wireless Ltd. (“Bittium”) warrants this Product, includ- ing all accessories provided in the sales box, against defects in materials or workmanship. If this Product is determined to be defective within the 1 year warranty... - Page 19 Notes Bittium Tough Mobile 2 Quick Start Guide...
- Page 20 Copyright 2019 Bittium. All rights reserved. The informa- tion contained herein is subject to change without no- tice. Bittium retains ownership of and all other rights to the material expressed in this document. Any reproduc- tion of the content of this document without prior written permission from Bittium is prohibited.
Need help?
Do you have a question about the Tough Mobile 2 and is the answer not in the manual?
Questions and answers