Troubleshooting - Stack Dash-2 User Manual

7. Troubleshooting

7. Troubleshooting 7. Troubleshooting
Symptom
Display is dead
!! LOW BATT !!
warning on display
Display flashes and dial
pointer resets or
vibrates
Display gives a fixed
temperature reading
Display gives a fixed
reading of 0 ° C or 0 ° F
when temperature is
above 70 ° C or 160 ° F
All sensors show fixed
high values
Peak values not updated Gate value set too
38
Possible Cause
Power switch is off Turn on
Battery is dead Recharge or replace
battery
Power connection Check if battery is
is faulty connected correctly. Check
power lead continuity
Battery is almost Recharge or replace
dead battery
Power connection Check power lead
is faulty continuity
Battery is almost Recharge or replace
dead battery
Power connection Check power lead
is faulty continuity
Temperature Replace sensor
sensor has failed
Faulty sensor Check continuity of sensor
connections leads
A temperature Replace sensor
sensor has failed
Faulty sensor Check continuity of sensor
connections leads for open circuits.
Switch 1 (Peaks) Return unit for repair
faulty
Change Gate RPM in the
high display configuration menu
Internal memory Return unit to Stack for new
battery dead battery service
STACK Dash-2 Kart Logger
Remedy
Disconnect
sensor.
Check harness
for short circuit
Display shows
!!MEM BATT!!
warning on power
up
Notes
Users Guide