Deciding On Speaker Placement; Three Tips For Determining Speaker Placement - Bose Virtually Invisible 191 Installation Manual

Bose virtually invisible 191: user guide
Hide thumbs Also See for Virtually Invisible 191:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
P
REPARATION

Deciding on speaker placement

Figure 4
Template
6
Nederlands
The design of your new Virtually Invisible
or ceiling installation. The location you choose will affect the procedure for installing them.
Consider the options below, then follow the instructions that apply to your choices:
• How you will use the speakers?
• for stereo sound at the front of a room or seating arrangement, or
• as home theater front speakers or surround sound rear speakers
• What surface will you install them in?
• an interior wall (abutting another room), or exterior wall (abutting outside), or ceiling
• in finished (plaster and lath or wallboard), or new construction

Three tips for determining speaker placement

1. The template can be placed against a wall or ceiling to help determine the amount of
space the speaker will need. Each speaker enclosure extends into the wall or ceiling, as
shown in the gray DO NOT CUT area on the template (Figure 4). In a wall, the speaker
may be inserted either up or down and will extend either above or below the grille.
2. Use of a stud finder can help ensure that the speaker hole is at least 4
a stud or joist.
3. All electrical wiring, vents and plumbing pipes located inside the walls must be avoided
(Figure 5 on page 7). Check with a trained professional to learn how to locate and avoid
them.
Note: To prevent problems with condensation in cold climates where a humidifier is used, avoid
inserting the speaker upside-down in an exterior wall.
WARNING: Make sure the spot chosen is safe for cutting. Do not cut through
surfaces that have hazards, such as electrical wiring, conduits or plumbing,
concealed behind them. If you are not sure, consult a professional installer
before you proceed.
8
1
/
" (20.5 cm)
16
Translations below
WARNING: Make sure the spot chosen is safe for cutting. Do not cut through surfaces that have hazards, such as electrical
wiring, conduits or plumbing, concealed behind them. If you are not sure, consult a professional installer before you proceed.
WARNING: Make sure the spot chosen is safe for
WARNING: Make sure the spot chosen is safe for
drilling. Do not cut through surfaces that have hazards
drilling. Do not cut through surfaces that have hazards
concealed behind them, such as electrical wiring,
concealed behind them, such as electrical wiring,
conduits or plumbing. If you are not sure, consult a
conduits or plumbing. If you are not sure, consult a
professional installer before you proceed.
professional installer before you proceed.
Pilot
Hole
WARNING: Make
1
5
/
" (14 cm)
sure the spot chosen
2
is safe for drilling. Do
not cut through
surfaces that have
WARNING: Make sure the
hazards concealed
spot chosen is safe for
behind them, such
drilling. Do not cut through
as electrical wiring,
surfaces that have hazards
conduits or
concealed behind them,
plumbing. If you are
such as electrical wiring,
not sure, consult a
conduits or plumbing. If you
professional installer
are not sure, consult a
before you proceed.
professional installer before
you proceed.
WARNING: Make sure the spot
chosen is safe for drilling. Do not cut
WARNING: Make sure the spot chosen is safe
through surfaces that have hazards
for drilling. Do not cut through surfaces that have
concealed behind them, such as
hazards concealed behind them, such as
electrical wiring, conduits or plumbing.
electrical wiring, conduits or plumbing. If you
If you are not sure, consult a
are not sure, consult a professional installer
professional installer before you
before you proceed.
proceed.
DO NOT
DO NOT
English & Translations
English &
ranslations
CUT AROUND
CUT AROUND
GRAY AREA
GRAY AREA
14
1
/
" (36.9 cm)
2
9" (22.9 cm)
DO NOT
DO NOT
CUT AROUND
CUT AROUND
GRAY AREA
GRAY AREA
DO NOT
DO NOT
CUT AROUND
CUT AROUND
GRAY AREA
GRAY AREA
DO NOT
DO NOT
CUT AROUND
CUT AROUND
GRAY AREA
GRAY AREA
Italiano
Français
®
191 speakers makes them well-suited to either wall
FOR CUTTING
Large white area
represents what to cut
out for the speaker face.
NOT FOR CUTTING
Large gray area
represents space to
reserve behind the wall
for the speaker
enclosure.
Deutsch
English
3
/
in. (12 cm) from
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Virtually invisible 191

Table of Contents