HP BRIO BA410 Manual page 81

Boot - for choosing your boot device order and priority.
•
You can select the order of the devices from which the BIOS (Basic
Input Output System) attempts to boot the operating system. During
the POST (Power On Self-Test), if the BIOS is unsuccessful at booting
from one device, it will try the next one on the Boot Device Priority list
until an operating system is found. The default boot device is the floppy
disk.
Exit: for leaving the
•
Setting System Defaults
The
initialization parameters. Setting incorrect values may cause system boot
failure. If this occurs, press the F9 key while you are in the
to load the
the Exit menu of the
boot properly.
Note If a Supervisor password is set, you need to enter the password to set system defaults.
HP strongly recommends you make a note of any changes you make while in the
All manuals and user guides at all-guides.com
program.
program changes system behavior by modifying the power-on
program's default values or select Load default values in
program. This should enable the computer to
HP Setup Program
program
program.
73