HP BRIO BA410 Manual page 28

My HP Brio Doesn't Start Properly
The PC Hangs and Emits Beeps During Startup
These beeps indicate errors in the very early stages of the boot sequence (refer to page 35)
Have you checked that ...
Your memory modules are of the correct type
The expansion card you have installed is
compatible
That you have not made any changes to the
PC's program that may be causing the
problem
I I I I f f f f t t t t h h h h e e e e p p p p r r r r o o o o b b b b l l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c o o o o n n n n t t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u p p p p p p p p o o o o rt rt rt rt p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r
You Get a "non-system disk" or "operating system not found" Message
Have you checked that ...
You didn't leave a non-bootable floppy disk in
your floppy drive when you started the PC
The device boot order is correct in the
program
The Power-On Self Test Detects an Error
An on-screen error message or more than one beep when the HP Brio starts up means that there is
a configuration problem with your PC. Refer to page 35 for more information on beep codes.
Have you checked...
The part of your configuration with which the
Power-On Self Test has detected an error
If you still have a problem
20
All manuals and user guides at all-guides.com
Ö
Ö
Ö
Ö
Ö
Ö
Ö
How
1 Disconnect the PC's power cord.
2 Remove the PC's main cover and lift out the power
supply (see page 51).
3 Replace the memory module with a known working
memory module (see page 65).
4 Reconnect the PC's power cord and start up the PC.
Disconnect the PC's power cord.
1
2 Remove the PC's main cover (see page 49).
3 Remove the expansion card (see page 66).
4 Reconnect the PC's power cord and start up the PC.
Enter the program by pressing F2 when
1
prompted during startup. Refer to page 72.
2 Reload the default
3 Press F10 to exit
How
Check for a non-bootable floppy disk in the floppy
1
drive.
2 Remove the floppy disk if there is one in the drive.
3 Restart the PC.
Enter the program by pressing F2 when
1
prompted during startup. Refer to page 72.
2 Reload the default
3 Press F10 to exit
How
For more specific troubleshooting information, refer to
"My HP Brio Detects an Error at Startup" on page 35
Run HP e-DiagTools (refer to page 42)
values by pressing F9.
saving changes.
values by pressing F9.
saving changes.