HP BRIO BA410 Manual page 36

Hardware Problems
The DVD Drive Doesn't Play DVD Video
Have you checked that...
The DVD disc you are trying to play and your DVD drive have the same regional code setting. Your DVD drive's
regional code setting is set by the first DVD disc you insert in the drive. After several uses the regional drive
becomes fixed and cannot subsequently be changed.
You have either a hardware or a software MPEG decoder installed on your system
Your PC's hardware and software configuration supports the playing of DVDs. The following configuration is
recommended:
At least an Intel Celeron processor with a minimum clock speed of 400 MHz.
64MB of memory (Windows 2000, Windows 98)
Display settings of 800 x 600 pixels, High Color (16-bit).
You are using the latest drivers. These can be downloaded from the HP Brio support Web site at:
You are not trying to play DVD video under Windows NT 4.0. DVD video is not supported by this operating
system.
You have enabled DMA mode on the Secondary IDE channel in the
during startup.
For more information on using and troubleshooting DVD, refer to the PC's online HP Brio Center
The CD-ROM, CD-RW or DVD Drive Doesn't Open
What to Do...
If you have difficulty removing a disc from the drive (during a power failure for example), you can use the
1
manual eject button.
With a thin, solid rod, such as the end of a paper clip, push the drive's manual eject button
2 The drive door will be released, opening slightly. Carefully pull it open fully and retrieve the disc.
3 To close the drive door, push it gently closed without forcing it. The drive door may not close completely
until it is fully functional (for example, when the power comes back on).
28
All manuals and user guides at all-guides.com
.
program, accessed by pressing F2